Pair of rubber front floor mats fit Land Rover Defender 90 110 TDCI, R380 & LT77

This listing is for a pair of front rubber floor mats suitable for all pre 2016 Land Rover Defenders. The mats have cut down sections to suit the different gear boxes.

To install, simply drop the mat into place and make sure which section you need to remove depending on your vehicle type before you cut the mat.

FITTING GUIDE

Once you have selected the panel to be removed, then cut along the outer raised edge (not the inner) as you need the raised edge to help to trap and dirt and grime on the mat. Shown above is the removal of the main section to convert the mats from fitting LT77 gearbox type to R380 & TDCi

YOU WILL NEED:

Either a sharp knife or a pair of decent scissors

If you are using a sharp knife then a hard surface to cut onto will be a good help.

• Easily removed for cleaning
• Chequer plate finish with oval logo
• Will fit either left or right hand drive
• lowered area for throttle pedal clearance
• Raised edge border to keep in mud and grime
• The Defender front floor mats are supplied in pairs
• Will fit all Defenders. 200Td, 300Tdi, Td5 & Tdci (Puma)
• Can be cleaned with water and detergent do not use an abrasive brush
• When placing in the drivers foot well of a 200Td (RH Drive LT77) a gap remains between the tunnel and the mat of about one and a half inch

ALL ITEMS ARE DISPATCHED FROM THE UK. IMPORT DUTIES MAYBE PAYABLE ON INTERNATIONAL ORDERS. UNLESS SPECIFICALLY STATED OTHERWISE OUR PRODUCTS ARE NOT SUITABLE FOR THE NEW SHAPE (2020+) DEFENDERS.